Reversible can be installed to either side of the door opening.
Rough opening for 36 x 80 pocket door.
This takes into account the thickness of a standard 3 4 inch doorjamb on each side.
If you have questions give us a call at 888 458 5911.
While a standard door height is 80 finished opening.
For reference standard interior door widths range from 24 36 finished opening.
36 x 80 x 4 9 16 max.
X 80 in 32 in.
Make the rough opening for a pocket door two times the width of the door plus 1 inch with a height of 84 1 2 inches from the highest spot on the subflooring.
This will give you room to space the door frame off of the sub floor.
D attach guides 1550 at bottom of opening and adjust so door is centered in opening.
Factory primed ready for paint.
Just add 2 to the width of the actual door size.
For 2 x 4 walls only.
Made of natural unfinished hemlock.
The difference between a rough opening and finished opening is usually 2 3 inches.
Getting the rough opening size right the first time will save you from frustration when installing your doors.
X 80 in 30 in.
The rough opening for the pocket door is the rectangle created by the wall studs.
Get this wrong and you will suffer later.
It s a very specific height and width both called out in the written pocket door installation instructions.
The rough opening will seem huge.
Repeat with other hanger door plate.
Refer to the charts below to determine what size of door you will need.
You should add 2 1 2 to the height of the actual door.
X 80 in 28 in.
Pocket door hardware 2 x 4 wall pocket door frames.
Framing rough opening sizes are really quite simple.
The rough opening is the foundation of your system.
1555ppk3 converging door kit.
Add 2 to 2 1 2 inch to the measurement of the door s width to determine the total width of the rough opening.
15113068 stain grade pocket door jamb kit.
Buy now buy now.
Jeld wen pocket door frame with frame and hardware.
While this opening looks very large it must accommodate the door once it slides in the pocket to open.
C mount door by locating door plate 1121 under adjusting bolt of hanger 1120 and tilting door until bolt will slide into seat of door plate 1121.
Adjust hangers 1120 for height and plumb with jamb.