Read these instructions and check to be sure all parts and tools are accounted for.
Polaris roof seal kit instructions.
Hardware kit 5 1 seal roof front 5814649 2883075 6 2 seal rops 5814651 2883075 7 2 seal roof side 5813845 2883075 8 1 seal roof rear 5813846 2883075 1 instructions 9928342 hardware kit 2207264 also contains hardware used for installation of roof liners.
Place the front steel roof plate a on rear steel roof plate b and tighten by fastening four m8 nuts 2 and relevant washers 1 as shown in figure.
Removal of the roof is accomplished in reverse order.
Remove the headliner remove the screws from the roof if necessary.
If vehicle is equipped with windshield.
Complete the installation of your ranger roof with a seal kit.
If installing optional light then refer to instructions included with light.
For ranger crew rear doors the rear cab seal kit is part number 2879657.
5 16 in 8 mm 4.
Ideal for full cab installations or when looking to further reduce unwanted interior noise.
To view the instructions for that kit click here.
The cab seal kit for ranger xp 900 ranger diesel other full size and ranger crew models is part number 2879385.
All full hard door kits for ranger models come with cab seal kits.
The following table lists the parts included in the roof kits as well as their part numbers.
Connect the light to the wire harness and use two screws included in that kit to secure the light.
Roof support channel then slowly tip liner up inserting lh and rh edges of liner between rops and roof seal.
To order that kit see your polaris dealer.
Turn the key to off position and remove from the vehicle.
Place rubber seal 10 in between steel roofs.
Apply foam tape u to front ridge of rear roof panel.
Through each doghouse and up through roof panel.
Place the vehicle in park.
P n 9924424 rev 02 02 13 printed in u s a.
The roof liner kit part number 2882914 is also sold separately.
Instr 9929112 rev 01 2018 04 page 2 of 4.
Install each clamp assembly onto front roof panel with four clamp fasteners o.
20 in lbs 2 n m 5.
Secure rear liner w by installing seven push darts.
Lh and rh liner edges between rops and roof seal.
Designed to keep out rain and dust it is the perfect addition to fully enjoy your accessory roof.
Otherwise install two each screws r and washers e through rear liner w into roof.
Repeat for rh side.
The premium roof kits 2882912 and 2882913 also contain parts and separate instructions for the installation of the roof liners.
Denotes parts available in hardware kit part number 2205976.
To order that kit or a part see your polaris dealer.
Please retain these.
Install seal y onto ridge of roof front roof panel.
To purchase a kit see your polaris dealer.
Torque clamp fasteners o.
